Trimble RTS/S/SPS: Radio Communication Issues
Trimble RTS/S/SPS: Radio Communication Issues
Problem: Instrument is disconnecting or won't connect to data collector.
Solution: Follow these steps:
- Verify antennas (tablet and RTS) appear to be in good working order.
- Change Radio Channels on instrument and match on tablet.
- Turn off Bluetooth on the tablet.
- Turn off WiFi on the tablet.
If none of these resolve the issue, equipment will need to be brought to the service center.
Related Articles
T100: Radio Troubleshooting
T100: Radio Troubleshooting Clients have reported seeing issues with the Radio for the T100 tablet connecting to a RTS unit after shutting down the tablet or putting the tablet in airplane mode. Typically the RTS icon will disappear in FieldLink ...FieldLink: RTS Icon Not Displaying in Connection
FieldLink: RTS Icon Not Displaying in Connection If you lose the RTS icon on the T100 table please follow the steps below to resolve the issue. Right-click on the Windows All Apps icon (should be in the lower left-hand corner of the screen) Select ...Trimble RTS/S/SPS: Field Columnation
Trimble RTS/S/SPS: Field Columnation Problem: Steps for performing a field columnation on Trimble robotic instrument. Solution: To perform a Tracker Collimation. Set up a deadman (flat prism, on a tribrach attached to a tripod) at 100m. Set up the ...Trimble RTS/S: Unable to Measure / Vibrating
Trimble RTS/SPS: Unable to Measure / Vibrating Problem: Robotic Total Station tracks the prism, but position does not update on data collector either through the map or through measurements. Solution: This is often caused by the instrument vibrating ...Trimble SCS900: Using an External Radio to Connect a non-radio T10
Trimble SCS900: Using an External Radio to Connect a non-radio T10 Problem: Is there an external 2.4 radio that is compatible with the non-radio T10 and SCS900? Solution: Yes, you can use the SPS4201 external radio. You will also need a 9 pin serial ...